egraphics 0 Posted March 4, 2010 So I have a newer Mac (10.5) - and just got my PC-60. I tried the following cables: serial to usb, parallel to usb.........both do not work. In the manual for the PC-60 (which is outdated), it says for a Mac (definitely the older ones) - to use the old school large, round 8 pin cable...... Well, the newer macs do not accept the old 8 pin cables...... So what cable to I use/need? The cutter powers on..........using SignCut (just need the cutting capabilities now). Thanks for any help! Lee Share this post Link to post Share on other sites