Sign in to follow this  
dugzphoto

CREATION PCUT CNT630 Driving me NUTS

Recommended Posts

OK, I was just given this Cutter/Plotter and I can not figure it out.  :angry: >:(:thumbsup:

1) If I use SIGNCUT PRODUCTIVITY PRO the head goes to the right and hits Kill button. I turn on, push the on-line button and the X and Y come up. I set the vinyl 1inch from the right side and cutter on the edge of vinyl, push center button, push on-line. Then when I go to cut image it goes to the right and hits Kill Button (15 times now) Image is only 5inch and vinyl is 24.

Also, I can not change size of image. Is this just a cutter program and nothing else?

2) If I use WINPCSIGN Basic, I can not set to Plotter. I am on COM6, it only goes to COM4

3) If I use WINPCSIGN Pro, demo version, I can set the Plotter, but since I am on DEMO it will not cut project it only cuts out the words DEMO

Share this post


Link to post
Share on other sites

To see if it is SC PRO as the problem move the head to the center and make it your home position.

Then cut the 5 inch decal.

See if that works.

You have plenty of room left and right to test without hitting the kill switch.

Also check your setting in main screen of SC PRO for vinyl witdh set.

Let us know your progress.

Paco

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this