Coffeelady 0 Posted March 1, 2010 I am very new to vinyl cutting and just purchased a Graphtec Craft Robo CC330-L20 for personal use and gift making. All I have done so far is make the "test cut" following the instructions on the video. I placed my paper on the carrier sheet at the appropriate marks. I had my image placed within the cutting area in the robo software...note even close to the edge. When the image cut, it cut the edge out onto the carrier mat and off of the paper. Is there a setting somewhere that should be adjusted? I'm know it's probably pretty simple, but as I said, I am very new to this! Thanks for any input! Coffeelady Share this post Link to post Share on other sites