rodbuilder 0 Posted February 24, 2010 OK - here's one I bet everyone has asked at one time.............. If you're doing a graphic for a car or truck - a wiggly pair of lines, say - cna you print out the graphic using registration marks then set it up in your Graphtec CE-5000 and do the contour cut? I have a Roland PC60 and the Graphtec, but the Roland is too old to contour cut, but I haven't tried using that feature yet on the Graphtec. I'm wondering of the Graphtec's optics will read registration marks through the laminate? Will it work??? Share this post Link to post Share on other sites
Gator Signs 0 Posted June 11, 2011 I have a ValueJet and I do it ALL the time. The laminate is clear so it doesn't cause a problem. Share this post Link to post Share on other sites
mopar691 281 Posted June 11, 2011 The Roland will contour cut, just have to do manual registration. Share this post Link to post Share on other sites