han7681 0 Posted January 7, 2010 HI as shown the photos, one corner in square is not clean. i have chaged the offset from 0-7.0 square size is 5*5cm all same results... any idea why? Share this post Link to post Share on other sites
Brandon_Davis 1 Posted January 7, 2010 What type of cutter?!? Share this post Link to post Share on other sites
han7681 0 Posted January 7, 2010 hi im usuing a pcut creation Share this post Link to post Share on other sites
MZ SKEETER 4,708 Posted January 7, 2010 HI as shown the photos, one corner in square is not clean. i have chaged the offset from 0-7.0 square size is 5*5cm all same results... any idea why? start with your offset at .25 then work at .05 intervals going + if it goes worse then start going minus- How did you come up with 0-7.0? Read the newbie manual. It will help you with alot.. Share this post Link to post Share on other sites