Dale 0 Posted January 3, 2010 Is there a way to keep the vinyl from returning to the start point after a job is cut? After the job is cut I want the vinyl to remain out the front of the cutter for easier access. Thank you in advance for any help. Share this post Link to post Share on other sites
Dakotagrafx 7,297 Posted January 3, 2010 When you send it to cut - under the cutter setup screen there is a radio button for advance after cut - that will do it! Share this post Link to post Share on other sites
Dale 0 Posted January 5, 2010 I totally over looked that! Thanks for the help Dakota! Share this post Link to post Share on other sites