shersher 0 Posted December 30, 2009 Hi, does anyone know if Signblazer or Sign cut or any of these will work with a Mac? I had a PC I was using and tonight it won't turn on, so I need an alternate until I can get that PC checked out. Also I have a PCut 630 Thanks in advance Share this post Link to post Share on other sites
Jay2703 704 Posted December 30, 2009 SignBlazer is not Mac Compatable. Share this post Link to post Share on other sites
Karl 0 Posted January 1, 2010 Flexi, Flexi starter, SignCutPro look around the forum, or better do a search (at top of page), there are a pelethera.. palethera.. a whole lot of conversations on the apparently ONLY two cutting programs for Apple's Mac-pc. for example there are 6 conversations in this forum near the top of the page, specifically on Mac cutting & software. I have both, Fs & SCP, there are some basic differences in the interface, a note; when reading remember that the flexi for Mac and the flexi for windows are slightly different, And as a temp fix, Sign Cut does have a "rental" system, so you could use it for a month, several months, year, etc at a lesser cost. But it is a plug in for illustrator or other regular graphics program, so you will need that also. Flexi starter Mac is about $150 has a rudimentary graphics, highly recommend illustrator for creation of graphics. Share this post Link to post Share on other sites
Rodger 527 Posted January 1, 2010 InkScape is a good software if it supports Mac Share this post Link to post Share on other sites
Karl 0 Posted January 7, 2010 NCI Magisign = an Illustrator plug in cutting, $600 Flexi Pro = a full blown graphics & cutting, $2000 Flexi starter = a very simple graphics & cutting interface, $150 Sign Cut Pro = a plug in for several graphic programs, cutting only, Here are the current prices SignCut-X2 3-Months Subscription $36 Share this post Link to post Share on other sites