Sign in to follow this  
jhelms

cutting with usb

Recommended Posts

I was cutting earlier and only cut 1/2 th 2foot logo and started getting aggravated soI read past entries and seen where a usb to 9 pin serial port cable would help a lot loaded the cabled sent over logo to cutter it recieves it but no cutting need help bad thanks jhelms

Share this post


Link to post
Share on other sites

I tried that and didnt understand or see usb to serial  i can not get it to work but usb to usb does partially getting worse wasnt nowhere as bad in past year thanks jhelms

Share this post


Link to post
Share on other sites

If you are using Signblazer,  just uninstall it, and try a fresh install of software and driver.  See if that helps,

Share this post


Link to post
Share on other sites

OK,

The extrenal serial to USB converter will behave as a virtual USB port.

If you are using USB to USB it will also create a virtual USB port as the serial to USB converter is build inside the plotter hardware.

So which serial to USB converter are you using?

What is shown in Windows hardware setting?

Which port is set in Windows hardware setting?

Same question for the setting in the SBE cutter screen.

If you have screen shots of them it would be nice to see where the problem is.

Share this post


Link to post
Share on other sites

I got one logo to put on before christmas I will try once I get this put on and will get back to both of you guys that way If it messes up I want be in a pinch thanks talk in a few days jhelms

Share this post


Link to post
Share on other sites

Hey Jhelms, if you're still having trouble with this after following those steps, you can submit a ticket at support.uscutter.com. 

We can work with you to get that working.  This is probably just your port setup, but we should be able to remote into your computer and set you up.

Share this post


Link to post
Share on other sites

Thanks yadirell Im going to get through christmas 1st and Ill give you guys a shout  Thanks jhelms

Share this post


Link to post
Share on other sites
Guest HowardI

I use PCut cutters here all day long using nothing but USB and they work fine - one of us in support can do a remote support session to help you out after you get your ticket created.

We look forward to hearing you are up and running.

Howard Irwin

Support Specialist

US Cutter

425-481-3555

888-298-8143

  - Option 2

Share this post


Link to post
Share on other sites

OK now im in business us cutters told me not to use radio shack serial to usb, take it back had problems with regular usb, but support tolD me to use the Keyspan serial to usb (usa-19hs)  I plugged it in with a little help from Dakota from another post( Thanks again Dakota) turned on cutter and opened signblazer and keyspan was under com7 immediatly and sent over small cut, it sent data to cutter almost instantly. just thought I would post maybe I can help down the road somewhere for some one else I want to thank everyone for there help especially support and also want to especially THANK YARO FROM SUPPORT the phone call you gave me helped a lot Thanks jhelms

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this