Sign in to follow this  
RAMEY22

NEED HELP WITH ORIGIN SETTING

Recommended Posts

I NEED SOME HELP GETTING THE CUTTER TO CUT WHATS ON THE SCREEN OFF OF SIGN BLAZER PROGRAM.....IT SHOW THE SIGNS OF CUTTING ON COMPUTER BUT THE CUTTER DOESNT CUT

Share this post


Link to post
Share on other sites

This is not necessarily an origin problem. The cutter may refuse to cut for a number of reasons. But if you need to set origin, hit the "On Line" button on the panel. This will get you to the origin setting. You can use the right or left arrows to move the cutter head. Once you have it at the starting point you want, hit the center button (between the arrows) and this will establish your origin point where the blade is resting.

Hope this helps.

Share this post


Link to post
Share on other sites

NO IT DIDNT HELP  COULD U SEND ME A NUMBER I CAN TALK TO YOU TELL YOU WHATS GOING ON? I JUST BOUGHT THIS AND I AM CONFUSSED

Share this post


Link to post
Share on other sites

Make sure you have the correct COM port selected and that the Buad rate on the cutter matches the Baud rate setting in the software.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this