SSW 0 Posted November 6, 2009 I need some help vectorizing this dragon fly. Its something I drew by hand and scaned into the computer. I am wanting to make a sticker of it. I used the bitmat trace in inkscape, but I didn't get a very good imagne. Thanks in advance for the help! Share this post Link to post Share on other sites
mark-s 1,126 Posted November 6, 2009 Looks like it was done in pencil need to clean up (erase) unwanted lines. Then go over lines with a fine point sharpie make sure lines are connected. Retrace. mark-s Share this post Link to post Share on other sites
bigbrad 0 Posted November 6, 2009 Try this one Dragon Fly.eps Dragon Fly.eps Share this post Link to post Share on other sites
tekcorps 50 Posted November 6, 2009 Needs work. dragonfly.eps dragonfly.eps Share this post Link to post Share on other sites
Guest TracMatt Posted November 7, 2009 dragon dragon.eps dragon.eps Share this post Link to post Share on other sites
SSW 0 Posted November 7, 2009 Thanks a bunch tracestar!!!! Share this post Link to post Share on other sites
Dakotagrafx 7,297 Posted November 7, 2009 nice work Share this post Link to post Share on other sites
Guest TracMatt Posted November 7, 2009 Thanks Scott. Total redraw in Corel. Tracee Share this post Link to post Share on other sites