StickaBam 0 Posted November 6, 2009 Hi all! I just got my new LaserPoint 24" cutter set up and decided throw a rather intricate image from some graphics software I bought a while back at it and see what it could do. I was very impressed and thought I'd share what the output looks like. I'm very happy with this new cutter Share this post Link to post Share on other sites
#D-zine# 2 Posted November 6, 2009 Congrats on the new cutter. Looks awesome, great job! Share this post Link to post Share on other sites
Dakotagrafx 7,297 Posted November 6, 2009 nicely done Share this post Link to post Share on other sites
mabscotthandyman 1,410 Posted November 6, 2009 Looks great Dan Share this post Link to post Share on other sites
Guest sciondrgn Posted November 6, 2009 Looks Great! Share this post Link to post Share on other sites
YadirellT 0 Posted November 6, 2009 Sweet image. Good job! Share this post Link to post Share on other sites
paulthechainsaw 0 Posted January 20, 2010 Great cut. If you don't mind my asking. What is your blade offset set at? I haven't been able to get the same results as you and I think it's my blade offset set improperly. Share this post Link to post Share on other sites
jeremySI 18 Posted January 20, 2010 nice, the addiction will begin Share this post Link to post Share on other sites
tattoo.dan 0 Posted January 21, 2010 i have the lp 24 at home in my garage. it did and still does a lot for me. pretty darn good cutter. Great cut. If you don't mind my asking. What is your blade offset set at? I haven't been able to get the same results as you and I think it's my blade offset set improperly. i will check my offset and pressure tomorrow for you if nobody else has responded. slow the speed down on these too... Share this post Link to post Share on other sites