Sign in to follow this  
Dakotagrafx

CE5000-60

Recommended Posts

I haven't had time to go thru the entire 122 page manual to find it yet but If I have the advance after cut selected in flexi the cutter will feed the roll non stop on the floor.  any ideas/  got to be some setting in the cutter as I never had a problem with the Pcut, refine or copam.

i do have to admit to finally being a serial convert.  using the usb the cutter froze after about 4 feet and had to be turned off to recover . . .went serial and no more problems

Share this post


Link to post
Share on other sites

No tried roll 1 and 2

got the cutter used so i am guessing it is a setting I have not came across yet - went to read my manual I printed and found I was short about 70 pages - so i reprinted but haven't got around to digging yet

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this