captonzoom 2 Posted August 29, 2009 Ok, two things. Thing number 1. My copam will not measure any more. it will measure left to right, but when it goes to find the "edge" it spits the vinyl out the back an onto the floor!! Thing number 2. Based on reccomendations, I Bought Flexi Starter 8.6v2. I am trying to make a test cut, my name. 2"x4" it cuts in reverse even though it is not in "mirror" mode on the screen and when it gets to the "A" in my name, the cutter stops and says "cutting"........ I have no more hair left to deal with this. any help would be very appreciated. Share this post Link to post Share on other sites
kenimes 42 Posted October 2, 2009 Optical eye for front to back feed is not reading the material correctly. Is it a lighter color vinyl? Maybe hold it down while it feeds to make sure the optical eye is covered by the material. Watch yer fingers. And you are making sure Scroll is flashing on the LCD when you have it measure- and not Sheet? Which cutter driver have you selected in Flexi? Share this post Link to post Share on other sites
Dakotagrafx 7,297 Posted October 2, 2009 oh Ken your still quick - I was going to say check the optical eye for debris or dirt Share this post Link to post Share on other sites