amv101 0 Posted October 12, 2007 I am new to the vinyl cutting world and not sure how to install the rollers that hold the vinyl on the PCut stand. Can someone help me out by explaining how they go, or show me some pics? I got these two metal disc, and from the pics it looks like the rubber grommets go around the shaft part of the disc and keep the disc from moving on the main roller shaft. And the main roller shafts have different length ends on them. Which side goes on which side? Seems that if you install the metal discs with the shafts pointing at eachother, and you place the vinyl roll on the roller shafts, in between the discs, the rubber grommets would make the roll of vinyl not roll flat during feed... I am sure I am doing it wrong. HELP! thanks, AMV Share this post Link to post Share on other sites