Pastimes 0 Posted July 1, 2009 Despite being computer savvy, my new LaserPoint 24" installation has humbled, humiliated and irritated me far more than it should. I experienced most of the negative issues found in the forums (I didn't think that any of these problems would happen to ME..hah..hah...) That said, I am not giving up on it. My first several cuts were pretty impressive. I THINK that I have worked through most of the glitches except for one: I continue to have Windows XP prompt the Found New Hardware routine upon boot up. When I go into Device Mngr., there is the "yellow- icon-of-the-unknown-hardware" showing up. Windows does not find the driver on the Bannana/Rose Disc and I did install SignBlazer from the included disc. Can any of you smart folks steer me in the right direction here? Share this post Link to post Share on other sites
CRD 9 Posted July 2, 2009 http://www.customracingdecal.com/manuals/Noob-V4_2.pdf In this manual is the link to the latest USB drivers used in laserpoints and Pcut machines. Just give it a try. Remove the marked port and then the USB cable. Install the driver (it is a simple exe file) The hook up cable again and found new hardware should install driver automaticly to the port. Do not switch ports every time. And let us know if this helped. Paco Share this post Link to post Share on other sites
Pastimes 0 Posted July 3, 2009 This is some excellent info. Is this the "new and improved" setup routine? This one is quite thorough and detailed. Thanks! Chris http://www.customracingdecal.com/manuals/Noob-V4_2.pdf In this manual is the link to the latest USB drivers used in laserpoints and Pcut machines. Just give it a try. Remove the marked port and then the USB cable. Install the driver (it is a simple exe file) The hook up cable again and found new hardware should install driver automaticly to the port. Do not switch ports every time. And let us know if this helped. Paco Share this post Link to post Share on other sites
CRD 9 Posted July 4, 2009 Thanks, The time I wrote this USCUTTER was making one too and I was not aware of. So just choose the one you like. I will add depending on what questions are rising often to this manual (if time allows). The USCUTTER I think will not change that quickly (but you never know). Paco Share this post Link to post Share on other sites
Brandon_Davis 1 Posted July 6, 2009 Give us a heads up ... Sounds like good info! Share this post Link to post Share on other sites
CRD 9 Posted July 6, 2009 Brandon, Use it and abuse it as I did with the original US cutter one We are on the same side but different back ground. Paco Share this post Link to post Share on other sites
Brandon_Davis 1 Posted July 6, 2009 Your the man, Paco! Share this post Link to post Share on other sites
