bmiller 0 Posted September 19, 2007 I just recieved my new pcut, and for the life of me I cannot load the drivers for the usb port, I'm using windows vista. Is there an easy way?? I'm not sure how to do it. I can't wait to start using the cutter and I look forward to getting to know some of you. thanks Share this post Link to post Share on other sites
kenimes 42 Posted September 19, 2007 Welcome to our forums!! Easiest way would be to unplug the USB cable from the computer. Go to www.uscutter.com then click on Downloads, then Refine Downloads. Point at the top selection and click, then click Run, and Run again. Once the driver is installed, plug the USB cable back in. Share this post Link to post Share on other sites