snlsd 1 Posted May 29, 2009 I don't know what I did, but something is causing my cutter to shrink the size down. I cut a word that was supposed to be 8 inches high, but it was barely a 1/4" tall when I cut. Is there a setting somewhere that I'm missing? What is causing this? Share this post Link to post Share on other sites
stryker1 0 Posted May 29, 2009 Is the only thing that you have cut that you are having problems with? Share this post Link to post Share on other sites
Jay2703 704 Posted May 29, 2009 Check that your units are not set to mm's instead of Inches. 8mm is about .3inch. It's in the upper left corner of the workspace where the rulers intersect. Share this post Link to post Share on other sites