Sign in to follow this  
Sparklequeen

Went to cut and this message popped up: Cannot connect to output device-HELP?

Recommended Posts

I got my machine, set it up and got all the way to cut tile and then this message popped up: Cannot connect to output device: Error initializing cutter.

Can anyone help me fix the problem? I am not familiar with these machines at all and have no clue where to begin.

Share this post


Link to post
Share on other sites

With SignBlazer, if you run into this again:

Make sure the software is communicating through the correct COM port, or if using a Refine or Copam, the correct LPT port as well.

Make sure the Baud rate on the cutter matches the Baud rate in comm settings of SignBlazer. Make sure the cable has not come loose.

Share this post


Link to post
Share on other sites

Thanks that is exactly what was happening. SO this will be informative for others running into the same problem. I switched the port in the setup to match my computer and Wahlah! It cut! Thanks so much!

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this