Sign in to follow this  
marcmcm

USB Problems

Recommended Posts

I had to get a new mtherboard and the new one doesn't have an LPT1 port.  The serial port i too close to the video port so the serial won't fit.  I'm left with USB and I installed the USB 2.0 driver and it still doesn't cut.  Which port do I tell it to use in Signcut? I tried Summa USB and Gamma USB and neither do anything.  The cutter worked great when hooked up LPT1, now it won't do anything.  Any ideas?

Share this post


Link to post
Share on other sites

I have the old Serial to USB.  I tried the old and new drivers, neither one is making it cut.

Share this post


Link to post
Share on other sites

Instead of using the old Serial to USB cable, you should now be able to use a direct USB to USB cable- like the same type of cable a printer uses.

Share this post


Link to post
Share on other sites

Instead of using the old Serial to USB cable, you should now be able to use a direct USB to USB cable- like the same type of cable a printer uses.

That would be great if my Copam had a USB connection on it.  All I have is parallel and serial.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this