RockerSigns

First Run problems??

Recommended Posts

Ok so I got the 1 color spots transfers. (a bunch)

I did my first batch of shirts and sweats.

Now the next day.... The transfer is cracking? Like splitting, just wearing the shirt??

Anyone know what could be the problem?

I heated to the recomended heat and time.

Now I have some angry customers on the first batch!

Danny

Share this post


Link to post
Share on other sites

When you say transfers, I assume you mean plastisol transfers?  If it's cracking, you didn't fully cure it.

Share this post


Link to post
Share on other sites

I don't have the slightest idea, but I would assume they would give you that info with the transfers.  If you are following those and not getting good results, you may want to check your press temp and pressure.  It may not be getting up to the correct temp.  Cracking indicates plastisols are not fully cured.

Share this post


Link to post
Share on other sites

Plastisol ink must reach a temp of at least 320degrees to fully cure.  Not too sure about using a heat press as I generally run them through a conveyor dryer after direct print.  Your problem may not be under curing but might be "over" curing  If plastisol over cured, it has a tendency to crack.  Try varying the heat and pressure on your press a bit and see if you can get a good transfer.  I'd definately contact whoever sold  you the transfers and ask for help.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now