barrypatch 0 Posted April 8, 2009 After reading lots and lots of posts, I decided to go with the Laser Point 24" with the stand. I am afraid if I don't get a contour cutting machine, I will regret it. I shouldn't need bigger than the 24" width. I am going to order the cutter with stand, Sisser easy weed in a few colors and Oracal 631 vinyl. I am going to start with vinyl to use with my heat press and vinyl for wall applications. I need some vinyl that I can use for stainless travel tumblers, I am not sure what to get for it. I can use my craft robo to cut it or the big machine. lol Any ideas on what to use. I have seen these tumblers on sites and they say to hand wash, but the vinyl stays on. Anything else I need to get? Thanks. Nancy Share this post Link to post Share on other sites
Fbomb 0 Posted April 8, 2009 Application tape Teflon Sheet IR temperature gun Squeegees Xacto knife + blades Work area As far as the tumblers, I am not sure. Maybe some cast vinyl. Welcome to the forum! Share this post Link to post Share on other sites