Guest Posted July 10, 2009 Good to know I am going to throw up a sticky right now. Share this post Link to post Share on other sites
Sandstormdesigns 2 Posted July 29, 2009 I need help learning howto contour cut with the FC8000. I watched the videos, read instructions and still nothing. I keep getting errors can't find Registration marks. It has been frustrating trying over and over again. I'm not even sure if the ARMS is working or not. Whether to use tool 1 setting or tool 3 setting. Every video assumes you know and skip whole procedures. Does anyone know about the FC8000 or using it? Share this post Link to post Share on other sites
Sandstormdesigns 2 Posted December 15, 2009 Is anyone using Windows 7 32 Bit or 64 Bit with the Graphtec's? If so, is the Cutting Plotter Control accessible unlike on Vista 64 bit? I am looking to switch operating systems from Vista 32 bit to Windows 7 32 bit. I just want to make sure that my FC8000 will work properly. Share this post Link to post Share on other sites
jim79 0 Posted March 15, 2010 SignLab 8 and Flexi 8.6 supported FC8000. Share this post Link to post Share on other sites