Graphtec FC-8000 tech

[Guest]

Good to know I am going to throw up a sticky right now. 

[Sandstormdesigns 2]

I need help learning howto contour cut with the FC8000. I watched the videos, read instructions and still nothing. I keep getting errors can't find Registration marks. It has been frustrating trying over and over again. I'm not even sure if the ARMS is working or not. Whether to use tool 1 setting or tool 3 setting. Every video assumes you know and skip whole procedures. Does anyone know about the FC8000 or using it?

[Sandstormdesigns 2]

Is anyone using Windows 7 32 Bit or 64 Bit with the Graphtec's? If so, is the Cutting Plotter Control accessible unlike on Vista 64 bit? I am looking to switch operating systems from Vista 32 bit to Windows 7 32 bit. I just want to make sure that my FC8000 will work properly.

[jim79 0]

SignLab 8 and Flexi 8.6 supported FC8000.