Sign in to follow this  
Arnold

Cutting To deep to not at all

Recommended Posts

I just received my cutter Monday when I try to cut; it cuts all the way though the vinyl and backing on the right side and cuts lighter as it cuts to the left. It does not cut all the way though the vinyl on about 1/2 of the left side

Share this post


Link to post
Share on other sites

Check the cutting strip, and make sure it is not coming up where the cut goes all the way through.

Share this post


Link to post
Share on other sites

It looks like it is all the way down. I push hard on it and it did not move. Could the stip be defective is it replaceable

Share this post


Link to post
Share on other sites

If it looks to be seated properly, then that might not be the issue. I have not heard of a cutting strip being defective, unless it is thicker on one side....not sure, and hard to tell. Yes, they are replacable.

You might want to make sure the blade holder is tight in the carriage arm. This is something I have not heard of yet......

Share this post


Link to post
Share on other sites

It is cutting good now. :) I have no Idea what I did to fix it. This is my first cutter so it is all new to me.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this