Sign in to follow this  
Cre8tiveCutter

Need Help attaching PCut to the stand

Recommended Posts

I cant figure out how the pcut is supposed to attach to the the stand! I have a little bag of screws but I sure dont see where they go...lol. Surely it doesnt just sit on top of the stand, doesnt seem safe to me! There are no holes in the bottom of the cutter nor on the stand. Help please!

Renee

Share this post


Link to post
Share on other sites

There are 4 long slots on the bottom of the plotter (in the plastic endcap parts)  There should be a threaded hole at the outside end of each slot.  The 4 provided bolts should be all that is needed to attach the machine to the stand.  Hope this helps

Share this post


Link to post
Share on other sites

thanx for the replies! We finally figured out that the holes were hidden and it took forever to get them lined up...lol. I'm happily cutting now though the static is killing me. I'm going to have my son ground it today and i will use dryer sheets on the vinyl as someone else suggested. I've ruined a few feet of tshirt vinyl because the cutter went crazy.

Renee

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this