Sweet_Ts 0 Posted January 29, 2009 More problems I am using the signblazer software on a mh-721 and it just wont make clean straight cuts...the carriage is on the tracks...the mainboard is brand new....the vinyl is being securely held by the rollers...its just looks like crap the corners are rounded and the straights are jagged....any suggestions? Share this post Link to post Share on other sites
JoeCamaro 11 Posted January 29, 2009 Check the blade holder. If it is cracked, it might be causing it. Did it fall or something? Share this post Link to post Share on other sites
firemalt 10 Posted January 29, 2009 or the blade is sticking out too far. Share this post Link to post Share on other sites
tlzimmerman 11 Posted January 29, 2009 Check blade offset in the software too......I had rounded corners till these guys helped me find that setting in sign blazer. Go to your cutter tab and then I believe its settings in there? Can't remember off the top of my head but set the offset of the blade, and you may try different settings until you get the cuts you are looking for. Share this post Link to post Share on other sites