Sign in to follow this  
veddderman123

Pinch Rollers?

Recommended Posts

When cutting a 24" peice of vinyl how far apart do you put your pinch rollers? 

When cutting up in the corner of a fresh peice of vinyl (with the roller a few inches from the edge) it keeps waving up and distorting the final graphic.  If I move the rollers closer to the edge then the center waves up.  Any advice?

Share this post


Link to post
Share on other sites

Material is not laying completely flat when you lock down the pinch rollers. Pinch roller tension on the PCut and LaserPoint series cannot be adjusted.

Share this post


Link to post
Share on other sites

I find if I set mine 1 inch from either side I have no issues. On some of the thinner vinyl I have to watch the job as it cuts as it will wave a bit but as long as the vinyl hangs off the cutter it helps on the thinner stuff not to float.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this