WalterD 0 Posted December 3, 2008 I sometimes have difficulty with some artwork created in Illustrator. Sometimes if I have a line of text, it will cut letters in the middle of the sentance, then go back and do the second letter and so forth. This results in an uneven line of type due to the cutter going back and forth. Is there a way to make sure that the cutter starts at one end of the vinyl and works its way to the other? I am working with a REFINE MH1300 on Mac plattform. Thanks Share this post Link to post Share on other sites
kenimes 42 Posted December 3, 2008 The cutter usually cuts from right to left, but I have seen where it acts the way you describe as well, and I have no idea why. Might be the way SignCut is reading your Illy file....not sure. I assume you are sending it to SignCut in .ai format? Does it do the same if you send it to SignCut in .eps format? Share this post Link to post Share on other sites
WalterD 0 Posted December 3, 2008 I always send it to SignCut in EPS format. I've heard that it might be the order in which the elements were created that make it cut that way. Not sure how to fix the order though. Share this post Link to post Share on other sites