kariquilts 0 Posted December 3, 2008 I have an opportunity to buy a Graphtec FC4100-130 with a PC and lots of software. My question is, Can I still get parts for this cutter? Also, I would appreciate any info/advice/opinions on this cutter. It is an auction, so the price is ?? at this point, but I am guessing I can get the entire set up for under $1000. Thanks in advance.... Share this post Link to post Share on other sites
kenimes 42 Posted December 3, 2008 We only started selling the GraphTec line of cutters just recently, with the FC7000 and FC8000, as well as the lower end CE series. If the 4100 is the same quality as the newer models, which I assume it is, then I would not hesitate trying to win that auction. GraphTecs are top of the line units. You might need to email GraphTec to see if parts are still available though... Share this post Link to post Share on other sites