Sign in to follow this  
alxjoy

tracking problemss

Recommended Posts

I have a creation pcut 24" plotter and the vinyl will not feed through or cut straight. Can anybody help me? 

  Thank you,

  Barry.

Share this post


Link to post
Share on other sites

no magic solution to this...you just have to keep feeding it back and forth,adjusting it,until you get it right.

Share this post


Link to post
Share on other sites

is the p cut like the laserpoint? where the grit coated feed roller is in two pieces? if so, you may have a loose set screw.

bb

Share this post


Link to post
Share on other sites
Guest

is the p cut like the laserpoint? where the grit coated feed roller is in two pieces? if so, you may have a loose set screw.

bb

Yes, the Pcut's feed rollers are the same as the LP's. If there is an obvious feeding problem this is probably the cause.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this