Sign in to follow this  
mastertec

PCut Reboot Issue Revisted Again

Recommended Posts

Hi Ken!

I don't know if you rmeember or not, but I had the PCut that when you tried to advance the vinyl, the unit would reboot. The posts were in September. I found out the carbon trace from the touchpad to the connector at the ribbon cable was the proble,. Well, it's done it again. Instead of removing the plug and hard soldering each trace from the carbon to the ribbon, could I get a replacement touchpad assembly? What do I need to do. Thanks!

Jeff Ward

Share this post


Link to post
Share on other sites

Replacement control pad for the PCut? No problem. PM me the address you want it shipped to, and remind me in the PM which part it is you need.

Share this post


Link to post
Share on other sites

I've sent you an email to the USCutter address. I appreciate this. This type of support is one reason I'm glad I chose USCutter over the others out there. Thanks again!

Jeff Ward

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this