Search the Community
Showing results for tags 'wont cut'.
Found 2 results
-
when i send the design (its a rectangle with the corners rounded) to cut it will always finish like in the picture (red circle) and the line should cut where the green line goes, i did a test cut (from the machine) and it made the square and diamond shape cut fine, i checked the design and its fine, i tried with the pen and plain paper and the drawing was correct, i checked with cutting pressure with 800g, 400g, 200g, 45g and all finish the same, i have always used redsail but tried liyu with the same end i dont know what may cause this since the design is fine, doing a test cut is fine and everything i try ends fine, but when i start to cut the job, it ends like that. i have the SC uscutter machine and using SignBlazer v6.0.5
- 5 replies
-
- finish circle
- sc uscutter
-
(and 1 more)
Tagged with:
-
Help! Has anyone seen the DRV ERROR - RESTART POWER message?? I have a TITAN 2 that is only 3 months old. I have ticket in with USC and was advised to move the carriage from left to right with machine off to correct error...no go on that one. I have disconnected all power sources as well to break connection. HELP? Have a big order to get out. Any advice appreciated.