Hello there, i found this community helpful by just reading the discussion so i registered to post my problem. I can see you guys are pros, im a newbie in cutting industry. Im from Palawan, Philippines..
This is my problem.. I have a red sail cutter that comes with a WINPCSIGN basic 2009 software. The cutter setting is good as it cuts the vinyl without cutting the backing. When i cut a single line word/sentence it cuts ok. But when i cut two lines, it is skipping some letters and not cutting the inside of first letter. For example O is just cut the outside not the inside.
I hope someone could help me. Thanks a lot in advance.