Search the Community

Showing results for tags 'sand carving'.

More search options

  • Search By Tags

    Type tags separated by commas.
  • Search By Author

Content Type


  • Welcome to USCutter
    • Shop Online
    • Customer Support
    • Information For New Equipment Owners
    • Website and Company Feedback
  • Equipment Discussion & Support
    • Vinyl Cutters
    • Heat Presses
    • Competitor Cutter Help
    • Printers
    • Laminators
    • Engravers
  • USCutter Community
    • Community Rules & Announcements
    • Introductions
    • General discussion
    • Show your work
    • Instructional Contributions
    • T-Shirts and/ or Garments
    • Sublimation
    • Business Practices, Sales and Pricing, etc.
    • Mac Users Board
    • Pre-sale questions
    • Off Topic Section
  • Software Discussion & Support
    • VinylMaster CUT, LTR, PRO & DSR
    • Sure Cuts A Lot Pro
    • Signcut
    • SignBlazer
    • Flexi
    • Corel Draw
    • Adobe Illustrator
    • Inkscape
    • Other Software Programs
  • Material Discussion
    • Vinyl
    • Other Materials
  • Feedback Section
    • Criticism and Complaints about USCutter
    • USCutter Equipment Feedback or Suggestions
  • Graphic help and requests
    • General Help
    • Vectorizing
    • Graphic Requests
    • Fonts

Find results in...

Find results that contain...

Date Created

  • Start


Last Updated

  • Start


Filter by number of...


  • Start





Website URL







Found 2 results

  1. I found a picture online where a black textured tint was applied to etched glass, which then looked like wrought iron. The textured tint was applied into the etching. Does anyone know of a textured tint to use on etched glass?
  2. oneearthjc

    Newbie looking for advice

    I am looking to cut vinyl primarily for use in engraving rough granite. I purchased a used (probably 15 years old) Roland Camm1 CM24 a couple of years ago and just cannot figure out how to get my Mac to "talk" to it. So, I'm throwing in the towel and starting from scratch. I'd like to spend $1500 or less but could spend a little more if I would get a better bang for my buck. I will obviously need software too. If it makes sense for me to buy a used PC instead of using my Mac, I would be open to that. Any advice would be greatly appreciated! Thanks