Search the Community
Showing results for tags 'rollers'.
Found 3 results
-
Hi there, I have the LP24 and was wondering how to tighten the pinch rollers? I am cutting 8.5 x 11 sheets of vinyl and it seems when the paper gets drawn back on the start of the cut, it hits a part of the cutter and it's throwing off the precision a bit. Also, I think my rollers are a little loose. I should know this but have never adjusted them before. Any advice is welcome. Thanks!
-
Hello I have problems with my U.S. Cutter MH 721 Plotter - Sing Blazer MK2 and software. When I try to send a cut from the Sing Blazer to a measure of 157.4 ", suddenly the Plotter start cutting random lines and derails sideways. Sometimes I can control the diversion Vinyl sideways. But the truth is I puzzles cutting problem, because it does not cut the actual design, but rather lines damaging the material. because I tried to put a cardboard box on the Plotter to rule out the static. But the truth is no longer what else I can do. I wonder ... will I need to configure something else ... such as a controller or USB port? - He added that achieves cut before the problem presented ... 76.7 "Frosted Vinyl in perfect condition. - Thank you very much for your help, Nancy.
- 7 replies
-
- Error Cut
- Random Lines
- (and 4 more)
-
Hey everyone, So I finally got my LaserPoint II cutter set up and my Mac recognizes the USB port just fine from SignCut Pro. I can adjust the knife settings from SCP using the arrow keys and the cutting preview looks spot on when I animate it from the preview window. Everything should be good on the USB port communication front. I thought everything was alright, so I started the cut this morning and once the machine started up, I noticed that the cutting blade was rotating as it should (in the shape of the design), but it was just cutting a jagged straight line across the edge of my vinyl (15" white Thermoflex Plus). When I looked at the cutter more closely, I saw that the grit rollers at the bottom of my machine were rotating, but the vinyl was not moving back and forth at all. So the cutting head is moving correctly based on the design I was cutting out, but since the vinyl was not being moved by the grit rollers, the cutting blade kept cutting the same row as it moved left to right (hence the jagged straight cut). I then tested the vinyl feed from the cut preview window in SCP (so I didn't waste anymore vinyl) and the grit rollers are moving while the vinyl just stays in one place. Does anybody know how to fix this? I think it's just a matter of the grit rollers needing to be adjusted so that they allow the vinyl to move back and forth easily, but since the operator's manual is less than helpful I figured I'd post a shout-out here for all of your expertise. (I also have a support ticket submitted, but I need to get this project done and support doesn't reply until Mondays). Thank you in advance.
- 6 replies
-
- LaserPoint II
- rollers
-
(and 1 more)
Tagged with: