I have read everywhere that to cut the mask for rhinestones, you need to cut each hole twice.
PLEASE tell me how!
I have Sign Blazer and Flexi 8.1. I can not find it anywhere.
I did discover that I can send the design to the cutter offline with the repeat set to 2 and when it finishes sending the file, I can press On Line and it will cut twice, but if I have more than about 125 holes, it doesn't cut at all unless I send it while on-line. Same if I send the whole file to the cutter. It cuts once, but if I go off line and hit the repeat, it dones not do it unless it's small.
I have spent hours searching for the answer to this. Any help is appreciated..
The file is 2 lines of text, total of about 546, 2.3mm holes. 1.8" tall x 9.5" wide.
Thanks
Tom