Search the Community

Showing results for tags 'position'.


More search options

  • Search By Tags

    Type tags separated by commas.

  • Search By Author

Content Type


Forums

  • Welcome to USCutter
    • Shop Online
    • Customer Support
    • Information For New Equipment Owners
    • Website and Company Feedback
  • Equipment Discussion & Support
    • Vinyl Cutters
    • Heat Presses
    • Competitor Cutter Help
    • Printers
    • Laminators
    • Engravers
  • USCutter Community
    • Community Rules & Announcements
    • Introductions
    • General discussion
    • Show your work
    • Instructional Contributions
    • T-Shirts and/ or Garments
    • Sublimation
    • Business Practices, Sales and Pricing, etc.
    • Mac Users Board
    • Pre-sale questions
    • Off Topic Section
  • Software Discussion & Support
    • VinylMaster CUT, LTR, PRO & DSR
    • Sure Cuts A Lot Pro
    • Signcut
    • SignBlazer
    • Flexi
    • Corel Draw
    • Adobe Illustrator
    • Inkscape
    • Other Software Programs
  • Material Discussion
    • Vinyl
    • Other Materials
  • Feedback Section
    • Criticism and Complaints about USCutter
    • USCutter Equipment Feedback or Suggestions
  • Graphic help and requests
    • General Help
    • Vectorizing
    • Graphic Requests
    • Fonts

Find results in...

Find results that contain...


Date Created

  • Start

    End

Last Updated

  • Start

    End

Filter by number of...

Joined

  • Start

    End

Group

AIM

MSN

Website URL

ICQ

Yahoo

Jabber

Skype

Location

Interests

Found 2 results

  1. LeeM
    !! Please help, just collected this used plotter and when I load the media, the pen reads the media width then when returning to the right doesn’t seem to know when to stop and throws this error. Y Position Alarm Power Off im not familiar with the system so don’t know how to reset etc. many advice gratefully welcomed. thank you FullSizeRender.mov
  2. dbc
    I have a little over an inch of cutting surface available that I can no longer set the origin point to. This is the furthest right I can move the head using the controls. When the cutter is off I can move the head just fine all way to the right; but the minute I turn it on it moves to it current position. Using the controls I'm able to move the the head to the left and right just fine, but no further right than this. If you look a red circle; shortly after I got the cutter, I was able to set the origin further right a one time. Any ideas? ...and why is this a problem? because of this I can't cut a full 24" wide design. Now the vinyl is too close the left side beyond where the print head can go.