Search the Community
Showing results for tags 'pinch'.
Found 2 results
timothyjay posted a topic in General discussionHi everyone! I hope I'm posting it in the right area - this forum seem to have a good amount of traffic so hopefully it can help. I apologize if it's not. New to decal/vinyl making, and got my SC Cutter 34" set up in no time today using Sure Cuts a Lot Pro 3 for Mac. Got the machine going and software set up, and made my very first print without too much headache - except for one minor issue: The pinch roller is leaving textured marks on the vinyl after a cut (attached is a photo of the finished piece after weeding - if you look at the B you can see the what I mean about the roller putting textured marks where the vinyl is being pushed down on the textured silver area). I'm using the 12"x5 yard Greenstar vinyl. Any feedback would be greatly appreciated
Hi there, I have the LP24 and was wondering how to tighten the pinch rollers? I am cutting 8.5 x 11 sheets of vinyl and it seems when the paper gets drawn back on the start of the cut, it hits a part of the cutter and it's throwing off the precision a bit. Also, I think my rollers are a little loose. I should know this but have never adjusted them before. Any advice is welcome. Thanks!