Search the Community
Showing results for tags 'orcal 631'.
Found 1 result
*** Figured it out, Its the new software, not the vinyl*** Curious if anyone has encountered striations across the width of rolled Oracal 631 that don't cut properly? I suppose it could always be my machine or a software issue? But i suspect its the material. Issue: The striations are across the width, not down the yardage. It is also across the width of the cutter - not down the length of the cut (like might happen with an old cut strip or obstruction in the machine) The ghost of a cut is visible, but at weeding, I need to use the edge of a blade to get the cut to lift. I've been increasing my blade, but i'm cutting into the backing across the vinyl, except in these bald areas The striation is in a different place if i cut the file a second time. Seems to be happening at an interval of 4", 12", 4", 12"... but that's measured after the fact. Before cutting, i don't notice any issue. Little sketch is what I'm thinking is happening. Other Details: I'm using a Silhouette Cameo & Sil Business software newest V4. New Blade, Replaced Cut strip & Mat - still happening older vinyl. Purchased extra in Dec 2015, and didn't break into until now. Vinyl is used for a resist process since I'm using the negative and discard the "object" I use painters tape for speedy weeding, and a blade for tough spots or areas where the resist scrim are broken up. Ive been using this material & method for years over 100s of projects. Thank so much for your time and thoughts. I appreciate any feedback. Kgi