Hi
I bought this cutter about 2 weeks. Im using vinylmaster cut that came with the cutter. Im trying to get clean cuts on designs. The designs are from the cameo software because I have i lot there and I dont want to start again doing all, so Im bringing them to VMC. Now, VMC vectorize the design and seen to me that the design is not so clean and straight lines no so straight lines.
Any idea how to have a clean design? should i use inkscape or illustrator to vectorize?
Im been playing with the pressure force, cutter speed, blade amount expose, etc. Right now i have
cut speed 700mm
cut pressure force 170g
up speed 400mm/s
baud rate 4800
blade offset 30mm for 45 blade
Design are coming funny so i dont like it. Can some one tell me if this setup is good? bad?
Other thing that i have notice is the blade holder, seen to me not straight and i thinking that causing problems, any idea? or suppose to be like that?
Thanks.