so my machine is pretty much new bought it early december 2016 it is now january 11 2017 last night i was cutting on oracal ultra gold leaf and machine went on a rampage about 4 times on me the design only measures 6.5 x 11 and as you can see in the image it just made a few cuts accross up and down. i tried cutting a bigger piece same logo at 22x13.5 and it cut it flawless so i down size to 6.5x11 and again its about 75% done and again starts to cut over the design. i am using a computer with windows xp and using vinyl master v4 with license activated and hooked up with the serial port. when this issue occurs the machine does the cuts accross that its not supposed to after its done doing these sorts triangle shapes it continues on its proper cut path as if nothing happened.