Search the Community
Showing results for tags 'incomplete cut'.
Found 1 result
dyndes posted a topic in FlexiI have been using Flexi 7.5 for years and have never had this problem. I will begin a cut that is six lines of text. When the cut get's sent, the production manager shows the percentage of completion. It stops processing at 83%. I get 5 complete lines of text properly cut and one line that does not cut completely. As well, if I must restart my computer if I want to send another cut. The production manager will say 'write port error'. I have ensured that my baud rates all match (on the plotter, the driver (device manager), and the production manager. (as stated in http://forum.uscutte...ite-port-error/ pinned post). It was set properly, and has always been set this way. I also lowered my buffer settings to assist in alleviating communication errors. 1 out of 10 cuts with aforementioned 6 lines of text will be erradic. The plotter seems to just go haywire and will cut a straight line until I tell it to stop (reset manually - or - exit production manager). Sometimes the line is vertical sometimes it is horizontal (and the plotter reaches the edge of the plot surface and attempts to continue heading in that direction). Does anyone else have any experience with this issue? Please respond with any information you believe may be relevant to my current issue. I still need to cut those 6 lines of text about 200 more times. *sigh* /dyndes