Search the Community
Showing results for tags 'ikea'.
Found 1 result
-
Having trouble with vinyl tracking? Tape 2 of these paper rulers on your cutter
PixelPusher posted a topic in Instructional Contributions
When I was in IKEA sourcing out my media basket parts for another DIY I'm stumbling through, I saw they had stands all over the store with hanging meter stick rulers that are IKEA branded digitally printed on paper. Customers are free to use them to measure items in their showroom when cruising around their store. They're free for the taking - I asked. I wouldn't take a whole pile of them in one go or anything but two here and there are perfectly acceptable according to the sales rep I was talking to and he encouraged it. It dawned on me that I could use two of these freebies taped onto my vinyl cutter (one on the front of the cutter and one on the back - upside down so the numbers and measurements could be read easily while facing the front of the cutter, both properly measured and aligned of course) to assist in lining up vinyl on the cutter for consistent tracking. Simply align the front most part of the vinyl from the roll or scrap piece to the same ruler line on the back of the cutter's ruler line (both left edge and right edge) and you're more than likely going to be tracking straight. Do some feed tests to see just how accurate or far off your alignment is and adjust accordingly. If you wear these rulers out over time, just replace as needed. They're also handy to quickly see if a scrap piece of vinyl you're wishing to use will fit a design you plan to be cut before you go through the hassle of setting it up. Checking the net, people do make an adhesive tape or transparent film type ruler too though for a more permanent and professional look for your cutter. A Bing Images Search shows adhesive ruler tape (Safe for work). An example of this is also attached to this thread. I don't know exactly where to buy this stuff but with some more Google searching, I'm sure one could obtain it.