Hi everyone.
I own a Creation PCUT CT630 with Flexi Sign 10 Basic version and it was going fine since I purchased it in 2015.
Lasat year it started to play up with the files. At thaty time I realised that i's the floppy USB Connector, thus I reconnected the cutter using 9 Pin RS232 Connector and it had been running fine since then
This morning it stalled while I was in the middle of cutting a 1220 mm X 500 mm Long Graphic with its screen showing "waiting". I had to turn the cutter off and turn back on.
Has anyone else experienced the problem with this cutter? Please help.
Also, I fouond that the graphics I cut differ in sizes by 1 mm over 1000 mm length both ways in X and Y. Is it something normal?
.
Regards
C.S.Kainth