Search the Community
Showing results for tags 'granite'.
Found 1 result
I am looking to cut vinyl primarily for use in engraving rough granite. I purchased a used (probably 15 years old) Roland Camm1 CM24 a couple of years ago and just cannot figure out how to get my Mac to "talk" to it. So, I'm throwing in the towel and starting from scratch. I'd like to spend $1500 or less but could spend a little more if I would get a better bang for my buck. I will obviously need software too. If it makes sense for me to buy a used PC instead of using my Mac, I would be open to that. Any advice would be greatly appreciated! Thanks