Search the Community
Showing results for tags 'force'.
Found 4 results
Hello! I work with Graphtec FC8600-160 for about one year. The problem is- Cutter use less pressure on very left side of cutting job. I use 53 inches- 137 cm. It's very thick over laminated material. I use special cutting knife for thick materials and it works pretty well, but I can not calibrate right pressure to cut all wok good. If the Right side is very ok, then left side is less ok, and opposite... May be some of had the same issue with other cutters or directly with FC8600-160?! Thanks!
Hi fellas, I've been having some weird trouble with mi USCUTTER MH 871, it doesn't cut vinyl, just leaves the mark, but doesn't penetrate. Even with the force on maximum. I just changed the carriage in hope that the old one was the cause, but the problem persists. Someone can help? Thanks!
Using a Titan 3SE with Vinylmaster DSR V4.0 and the Force Control box is now missing. Normally there is an option to set the Force and Speed. Perhaps I clicked a check box somewhere to turn this option off. Any ideas how to get this back? Thanks in advance!
Hello! This is a total noob question, what are the "best" force and speed settings for Oracal 651 on a USCutter MH721? I've had the machine for 5-6 years and use it sparingly - cut decals for my motorcycle club, for friends, etc. I set it up, found what worked for me and never thought twice about it. I was trolling the interwebs for something completely unrelated and saw my cutter, which lead me down a rabbit hole to the forum and got me to thinking... Anyhoo, looking for a recommendation :-) TIA! ~rob