I am using my MH-365 cutter to cut out a 3 digit number ("246") with 8" tall lettering using "Berlin Sans FB Demi" font. It looks perfect on-screen. The preview before sending to the cutter looks great, centered, none of the numbers overlap each other. According to the ruler, there is just over 1/2" gap between the "2" and the "4"
But when the cutter cuts the numbers, the "4" is shifted left by over an inch which causes the "4" to overlap the "2". The spacing between the "4" and "6" is shrunken too but not by the same amount. In the preview, there is a 1/2" gap between the "4" and the "6" but in the cut version, the gap is shrunk to 1/4". Another odd artifact, the "2" isn't closed...the cutter fails to fully cut the bottom of the shape of the 2.
Funny thing, if I rotate the numbers by 90degrees, they cut just fine. Is this a bug in the application? Or do I have an offset or something misconfigured in the page or cutter setup?
Fortunately after the first bad cut, I swapped to the pen to "plot" the results instead of burning up vinyl.