Search the Community
Showing results for tags 'cs630'.
Found 2 results
Hi everyone. Hope you're doing well. I recently bought a PCUT CS630 and i'm having some problems. I sent something to cut from Signblazer but all that happened is the cutter showed 'Working... COM1-CONNECTION' on the screen. Nothing else happens. I have attached an image showing you exactly what it displays and have also noted down more info below. I'm running Windows 7 64 Bit. I installed the USB Driver that came with the CD. The driver is 'CDM20802'. It states that 64 Bit is supported. The cutter is connected to the computer via the USB cable that came with it. It also has an SD Card slot but I am unsure how to properly save a file from Signblazer to it. I have Signblazer installed and it seems to be working fine. I have already done a cut test using the cutter itself with no software, but this time I wanted to test my cutter with signblazer for the first time so I created a 2 x 2 square. I went to 'Setup' within the cutter area. Unfortunately my PCUT CS630 is not listed with the rest of the Creation cutters. So I just chose the PCUT CT630 instead. I've also tried others. I chose the correct Output Device (same as the one in my device manager). I clicked OK and then clicked 'Cut!' and then finally 'Cut Tile'. The cutter then recognized that I clicked 'Cut Tile' and then Optic Eye turned on. However. The cutter didn't start. It just showed this message on screen. Nothing else. Does anyone have any idea what's going on? Thanks alot.
TheCuttingGuy posted a topic in Creation PCUT Cutting Plotter DiscussionHi there! I've been trying this on and off for months but I just cannot get it to work. I have happily been using my Creation PCUT CS630 in Corel Draw to cut vinyl (using the special plugin), but I really want to start contour cutting, which I don't think can be done in Corel and can only be done by using software like Signblazer and Flexi. I have Flexi 10 and my cutter will not cut at all. The furthest I get is after clicking the final 'Send' button, the cutter recognises something but then displays 'Working... COM1-CONNECTION'. It stays on this screen so I have to just turn the cutter off to remove it. I think i'm doing most things right. I plug the cutter in via the USB cable that came with the cutter, I find the correct port in device manager, in Flexi I choose my cutter along with the correct port. There could be just one little option that needs to be enabled or disabled but I have no-idea. I also using Windows XP so I don't think it's a problem with the operating system being too new or something like that. I also tried it on Windows 7 and the same thing happened. Any help would be very much appreciated. I'm so tired of trying! Thanks!