Hi
I have a 600 mm Creation PCUT 630 vinyl cutter. I put up a new blade yesterday as the previous one was damaged. I had to put up an aftermarket blade I got from EBAY as the supplier had them out of stock and I had some urgent work to do.
I ran the blade on following setting
Press: 86
Speed:40 (small text was to be cut)
I found that the edges are not coming up square. Please have a look at the attached picture. The word CARBON is a mess.
Is it the problem with the knife offset or may be because of new blade it was going deep into the vinyl?
Do we need to adjust the knife offset every time we change the blade please?
Please share some inputs
Regards