Search the Community
Showing results for tags 'bn20'.
Found 2 results
-
I have more than a year old Roland BN20. Last week after setting up the sheet the printer head goes across the sheet and fails to recognize the roller pincher position and gives the error and the light blinks continuously and the machine beeps The pinch roller position is incorrect Sheet setup failed After you have eliminated the cause of the error.setup the sheet again. I checked with a 9 inch roll too it still just goes right past the wheel and shows the error I checked whether the wheel is in the smooth part of the roller but it was setup correctly, I even brought over a technician and even he said there should be no reason for the error. I even reinstalled and installed the drivers and software, so could it be a problem of the hardware. if so which part should I replace? PS:- I live in the Maldives where there is no Roland service/repair centres.
-
Hi I have a problem whit the Cap Top emssanble, i was take out the Top Cap and by mistake i toke out the hold base and it wont fit agian Any Help?